Level in the traditional flow chamber dryer, the air flow for the laminar flow, only the surface of the flow of materials, the drawback is the low heat transfer coefficient, thermal utilization of poor drying time. In order to overcome the shortcomings of the above, according to the design of advanced foreign technology developed box-type wear-flow dryers.
　　CHG Series wearing oven by the fan flow of fresh air after some of the early, middle and senior-effect filters to purify 100,000, by the steam heat exchanger, warming the air to a certain temperature, hot air through the filter allows water, and then shunt from the left sub-board to all levels so that on average hot air through each of the materials were dry. Humid air from the bottom plate of the tilt bake Road out of the wind, after centrifugal fan so that part of the wet air from oven, and the other part of the air to continue the cycle of heating to achieve the purpose of drying.
　　Equipment characteristics:
　　Each cycle of hot air through high efficiency or high-performance sub-filter filtering, can effectively avoid the air entrainment recycled materials in the heating process of degeneration occurs, the pollution of the drugs in full compliance with the "GMP" pharmaceutical production norms.
　　Wear than the stratospheric flow type oven drying oven capacity, each thickness of material filling the stratosphere, more than three times-style oven.
　　Wear streaming large oven-drying, high efficiency, advection-style oven than 3-6 times as large, relatively low cost.
　　Suitable for a variety of granular, bulk dry goods.
　　Easy to clean and convenient to replace, low failure rate.
　　Air import and export are air filters, will not be dry materials contaminated, affecting its quality.
　　Oven heat source can be steam or electric heating.
　　Working Principle:

型号规格	每次干燥量	配用功率	耗用蒸汽	加热面积	风量	上下温差	烘盘尺寸	烘盘数	重量	外形尺寸
CHG-C-I	100	4	40-80	50	4000-7300	± 2	550×610×80	10	2200	2580×1400×2280
CHG-C-II	200	7.5	80-120	80	7200-15800	± 2	550×610×80	20	4000	3500×1600×2280